3/22/2021 0 Comments Xfinity 10.0.0.1 Admin Password
I would also rename the modems wifi networks back to their original names after disabling band steering.
Xfinity 10.0.0.1 Admin Password As PasswordI then tried Username:admin and the current WiFi password as Password.Since all the support docs on resetting the Arris begin with doing exactly what I am doing.Im stuck.I saw the modem reset and sure enough my wifi settings were reset however still no luck on the password. This time I just kept holding it down; I did not release the reset button until I saw the LED on the modem turn orange. After that when i re-connected to the default wifi and opened I was now treated to a first time setup screen instead of a login screen. Xfinity 10.0.0.1 Admin Full Factory ResetI followed the steps (setting my wifi ssid and pass phrase) then after it switched over to my named ssid when I reconnected I got the standard admin portal and this time the default credentials worked as advertised (admin:password):woohoo: I think holding the reset for 10s then releasing is a reset but holding the bugger down until the modem cries uncle is a full factory reset and that fixed my issue:1. To run an Arris router reset to the original factory settings, locate the same pinhole on the back of your modem. Use the paperclip to press the button inside the hole but hold the button down for a full ten seconds this time. The default Wi-Fi credentials are written on the label on the bottom of the unit, and you should also be able to connect using WPS. I got Ignite installed a week or two ago and have been really impressed with it. I used to have to run the Rogers modem in bridge mode up to an access point on the main floor but with the pods it seems to be unnecessary now. The issue Im having is that the access point is still active and broadcasting 2 SSIDs (2.45GHz) and I cannot log into the router since it had a static IP and the local network changed from 198. I guess my question is do I really need a router there anymore (Archer C9) or would a switch be better Note that the access point is in my office so I do have my PCprinter and another couple devices plugged in there. If not I will likely just power down or factory reset the Archer C9 Secondly, if I do disable to access point am I able to tell certain devices to connect only to the 5GHz band of the Rogers routerpods since there seems to only be a single SSID as both the 2.4 and 5 GHz bands were set up by the tech with the same name. That configuration is not supported by Rogers but it does work. If you had any problems, you would have to the modem to Gateway mode for troubleshooting purposes with Rogers techs. The solution at this time is toswitch to Gateway mode, enable Dynamic Frequency Selection (DFS) in the modems wifi controls and set the 5 Ghz channel to some DFS channel above channel 44 and below channel149. Id set the 5 Ghz bandwidth to 20 Mhz to give you a wider choice of individual channels. If youre near an airport weather radar, which overlaps with the DFS channels, the modem will change channels on its own to another channel. If the channel is clear and isnt overlapped by an airport weather radar, it should stay on its assigned channel. ![]() The modem does apparently have Safe Search DNS choices built in, so if you happen to need Safe Search settings for kids, you can do that with the modem. If you want to use the router as a wifi access point, turn off the firewall and DHCP server only. If you were using the modems wifi, I would personally disable band steering as I prefer to decide which band any given device will be connected to. That will hopefully prevent any issues where band steering is attempting to control the band that a particular device is running on, while youre connecting to, or already connected to the router, which is located somewhere else in the home.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |